Shipbucket
http://shipbucket.com/forums/

Renewing the old parts sheets
http://shipbucket.com/forums/viewtopic.php?f=23&t=491
Page 34 of 35

Author:  erik_t [ March 25th, 2014, 9:10 pm ]
Post subject:  Re: Renewing the old parts sheets

Looks pretty solid to me. The I-mast family is really a very attractive family of systems.

Author:  MihoshiK [ April 12th, 2014, 2:09 pm ]
Post subject:  Re: Renewing the old parts sheets

I decided to use the Millenium gun on one of my kitbashed ships, just for looks. Turns out, the old part was not all that. I left the foot unchanged, but completely redid the turret itself.

And then decided not to use it :D

[ img ]

Author:  acelanceloet [ April 12th, 2014, 2:16 pm ]
Post subject:  Re: Renewing the old parts sheets

while you are at it, could you also check if it has any deck penetration? or an version with deck penetration? if not, the addition of an simple red line makes it suitable for the belowdeck parts thread as well :P

Author:  MihoshiK [ April 12th, 2014, 2:34 pm ]
Post subject:  Re: Renewing the old parts sheets

acelanceloet wrote:
while you are at it, could you also check if it has any deck penetration? or an version with deck penetration? if not, the addition of an simple red line makes it suitable for the belowdeck parts thread as well :P
IIRC it's completely bolt-on. Just needs power lines. All ammo is carried in the turret itself.

Author:  Charwhick [ April 13th, 2014, 1:16 am ]
Post subject:  Re: Renewing the old parts sheets

The Penguin can be launched by helicopter, so it would be fitting to have a proper-scale version to fit on helicopters, because the normally enlarged-scale missile would look quite silly on a helicopter.

[ img ]

Author:  heuhen [ April 13th, 2014, 11:17 am ]
Post subject:  Re: Renewing the old parts sheets

Charwhick wrote:
The Penguin can be launched by helicopter, so it would be fitting to have a proper-scale version to fit on helicopters, because the normally enlarged-scale missile would look quite silly on a helicopter.

[ img ]
have you Down scaled IT from my Version.

Author:  Charwhick [ April 13th, 2014, 5:28 pm ]
Post subject:  Re: Renewing the old parts sheets

I used your version for the outline and cleaned it up (obviously a straight downscale wouldn't work)

Author:  Thiel [ April 13th, 2014, 6:04 pm ]
Post subject:  Re: Renewing the old parts sheets

acelanceloet wrote:
while you are at it, could you also check if it has any deck penetration? or an version with deck penetration? if not, the addition of an simple red line makes it suitable for the belowdeck parts thread as well :P
It's literally a bolt-on part, two 22mm ISO bolts in each corner IIRC.

Author:  KHT [ April 13th, 2014, 6:11 pm ]
Post subject:  Re: Renewing the old parts sheets

A fine, and simple addition to the dingy. ;)

Author:  heuhen [ April 13th, 2014, 6:29 pm ]
Post subject:  Re: Renewing the old parts sheets

BTW. Mk1-2 and mk-3 penguine had same wingspan, but the mk3 are longer than mk1-2 penguins, due to more fuel and bigger boster.

Page 34 of 35 All times are UTC
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/