[Post Reply] [*]  Page 1 of 1  [ 3 posts ] 
Author Message
maxwell john
Post subject: A questionPosted: June 29th, 2020, 1:52 pm
Offline
Posts: 14
Joined: September 23rd, 2018, 9:01 pm
Perhaps this seems silly as a question, but I am kinda new here so I'm asking anyways.

For the parts sheets, when taking the parts to use in drawings can you just snip the individual part you need? Or is their a way of copying each part separately to add to a drawing.

Thank you!


Top
[Profile] [Quote]
Cargil48
Post subject: Re: A questionPosted: June 29th, 2020, 6:47 pm
Offline
Posts: 122
Joined: April 1st, 2018, 9:07 pm
Location: Porto, Portugal
maxwell john wrote: *
Perhaps this seems silly as a question, but I am kinda new here so I'm asking anyways.

For the parts sheets, when taking the parts to use in drawings can you just snip the individual part you need? Or is their a way of copying each part separately to add to a drawing.

Thank you!
I for my part I download the entire sheet using Paint, name it according to its title and save it where I find it appropriate. Then, using Paint again for a drawing, I get to "Open" to open that specific sheet and outline the part I want to copy for pasting in my drawing. Did it help?


Top
[Profile] [Quote]
maxwell john
Post subject: Re: A questionPosted: June 29th, 2020, 6:48 pm
Offline
Posts: 14
Joined: September 23rd, 2018, 9:01 pm
Ah yes it does! Thank you very much


Top
[Profile] [Quote]
Display: Sort by: Direction:
[Post Reply]  Page 1 of 1  [ 3 posts ]  Return to “General Discussion”

Jump to: 

Who is online

Users browsing this forum: No registered users and 6 guests


The team | Delete all board cookies | All times are UTC


cron
Powered by phpBB® Forum Software © phpBB Limited
[ GZIP: Off ]